Default Settings; System; Tabelle 69: Cli "System" Configuration - WAGO 852-1813 Handbuch

176 Anhang
10.2.2

Default Settings

10.2.2.1

System

Tabelle 69: CLI "System" Configuration

Node
enable
enable
enable
enable
configure
configure
configure
configure
configure
eth0
eth0
eth0
eth0
eth0
Handbuch
Version 1.0.0
Command
ping IPADDR [–c COUNT] This command sends an echo request to the
ping IPADDR [–s SIZE]
ping IPADDR [–c COUNT
–s SIZE]
ping IPADDR [-s SIZE –c
COUNT]
Reboot
hostname STRINGS
interface eth0
configure terminal
interface eth0
Show
ip address A.B.C.D/M
ip address default-gateway
A.B.C.D
ip dhcp client
(disable|enable|renew)
management vlan
VLAN_ID
WAGO-Industrial-Switches
852-1813 Lean-Managed-Switch
Description
destination host.
The –c parameter allow user to specific the packet
count.
The default count is 4.
This command sends an echo request to the
destination host.
The –s parameter allow user to specific the packet
size.
Valid range: 0 ... 1047 bytes
This command sends an echo request to the
destination host.
The –c parameter allow user to specific the packet
count.
The default count is 4.
The –s parameter allow user to specific the packet
size.
Valid range: 0 ... 1047 bytes
This command sends an echo request to the
destination host.
The –c parameter allow user to specific the packet
count.
The default count is 4.
The –s parameter allow user to specific the packet
size.
Valid range: 0 ... 1047 bytes
This command reboots the system.
This command sets the system's network name.
This command enters the eth0 interface node to
configure the system IP.
This command enter the configuration mode.
This command enter the configuration mode of the
interface.
This command show information about eth0.
This command sends an echo request to the
destination host.
The –c parameter allow user to specific the packet
count.
The default count is 4.
The –s parameter allow user to specific the packet
size.
Valid range: 0 ... 1047 bytes
This command configures the system's default
gateway.
This command configures a DHCP client function for
the system.
"Disable": Use a static IP address for the switch.
"Enable & Renew": Use the DHCP client to get an IP
address from the DHCP server.
This command configures the management VLAN.