Stp - WAGO 852-1813 Handbuch

WAGO-Industrial-Switches
852-1813 Lean-Managed-Switch
10.2.3.5

STP

Tabelle 81: CLI "STP" Configuration
Node
enable
enable
enable
enable
enable
enable
enable
configure
configure
configure
configure
configure
configure
configure
configure
configure
configure
configure
configure
configure
interface
interface
interface
Command
show spanning-tree active This command only displays STP information for
show spanning-tree
blockedports
show spanning-tree port
detail PORT_ID
show spanning-tree
statistics PORT_ID
show spanning-tree
summary
clear spanning-tree
counters
clear spanning-tree
counters PORT_ID
spanning-tree (disable |
enable)
spanning-tree algorithm-
timer forward-time TIME
max-age TIME hello-time
TIME
no spanning-tree
algorithm-timer
spanning-tree forward-time
<4–30>
no spanning-tree forward-
time
spanning-tree hello-time
<1–10>
no spanning-tree hello-
time
spanning-tree max-age
<6-40>
no spanning-tree max-age This command configures the default values for the
spanning-tree mode (rstp |
stp)
spanning-tree pathcost
method (short | long)
spanning-tree priority
<0-61440>
no spanning-tree priority
spanning-tree bpdufilter
(disable | enable)
spanning-tree bpduguard
(disable | enable)
spanning-tree edge-port
(disable | enable)
Description
active ports.
This command only displays STP information for
blocked ports.
This command displays STP information for the
interface port.
This command displays STP information for the
interface port.
This command displays a summary of port states and
configurations.
This command clears the STP statistics for all ports.
This command clears the STP statistics for a specific
port.
This command disables/enables the STP function in
the system.
This command configures the bridge times ("Forward
Delay," "Max Age" and "Hello Time").
This command configures the default values for
"Forward Delay," "Max Age" and "Hello Time."
This command configures the "Forward Delay" period
(in seconds) for the bridge.
This command configures the default values for
"Forward Delay."
This command configures the "Hello Time" period (in
seconds) for the bridge.
This command configures the default values for the
"Hello Time."
This command configures the "Max Age" period (in
seconds) for bridge messages.
"Max Age."
This command configures the STP mode.
This command configures the path cost method.
This command configures the priority for the system.
This command configures the default values for the
system priority.
This command configures enables/disables the
"BPDU Filter" function.
This command configures enables/disables the
"BPDU Guard" function.
This command enables/disables the "Edge Port"
setting.
Anhang 187
Handbuch
Version 1.0.0