Carbon Filters; Lighting - KKT KOLBE CURVE Benutzerhandbuch

Care and cleaning
• Soak the metal grease filters well in
hot rinse water, then clean them with
a soft brush and then rinse well with
hot water. If necessary, repeat the
process.
• When cleaning metal grease filters
take care not to damage the mesh.
• The metal grease filters can also be
cleaned in the dishwasher in a stan-
dard program with 55 ° C.
To avoid fatty deposits on dishes or
the accumulation of food particles in
the mesh of the filter, the metal filters
should be cleaned separately from di-
shes and glasses. Heavily soiled metal
filters should first be soaked well in
hot rinse water.
• Allow the filter to dry thoroughly and
carefully replace it in the extractor
hood.
• Frequent cleaning or the use of ag-
gressive cleaning agents can cause
color changes of the metal surface.
These have no influence on the filter
function and are not a reason for
complaint.
!
Avoid using alkaline cleaning agents
(ph value over 7).
34

5.2 Carbon filters

The carbon filter neutralises unpleasant
odours from the room air, which is nee-
ded when operating the extractor hood
in recirculation mode.
• Traditional carbon filters (normally
round in shape) can be neither
washed nor regenerated.
They must be replaced.
• Replacement interval for carbon filters:
every 9 - 12 months according to fre-
quency of use.
• To remove the activated carbon filter
see installation chapter; assembly in
reverse order.
Original carbon filter
for this model: K606
6.

Lighting

!
• The LED lighting may only be repaired
or replaced by qualified personnel.
• For this purpose, the appliance must
be disconnected from the power
supply.
• When changing a lamp, make sure
that the new lamp does not have a
higher wattage than of the original.
• Before connecting the hood, check
that the voltage indicated on the
rating plate (V) corresponds to the
supply voltage in your home.