Activated Carbon Filters; Lighting - KKT KOLBE BOX 400 S/W Benutzerhandbuch

Care and cleaning
• Soak the metal grease filters well in
hot rinse water, then clean them with
a soft brush and then rinse well with
hot water. If necessary, repeat the
process.
• When cleaning metal grease filters
take care not to damage the mesh.
• The metal grease filters can also be
cleaned in the dishwasher in a stan-
dard program with 55 ° C.
To avoid fatty deposits on dishes or
the accumulation of food particles in
the mesh of the filter, the metal filters
should be cleaned separately from di-
shes and glasses. Heavily soiled metal
filters should first be soaked well in
hot rinse water.
• Allow the filter to dry thoroughly and
carefully replace it in the extractor
hood.
• Frequent cleaning or the use of ag-
gressive cleaning agents can cause
color changes of the metal surface.
These have no influence on the filter
function and are not a reason for
complaint.
!
Avoid using alkaline cleaning agents
(ph value over 7).

6.2 Activated carbon filters

The activated carbon filter neutralises
unpleasant odours from the room air,
which is needed when operating the
extractor hood in recirculation mode.
• Traditional activated carbon filters
(normally round in shape) can be
neither washed nor regenerated.
They must be replaced.
• Replacement interval for activated
carbon filters: every 9 - 12 months
according to frequency of use.
• To remove the activated carbon filter
see installation chapter; assembly in
reverse order.
Original activated carbon filter
for this model: K606
7.

Lighting

!
• The LED lighting may only be repaired
or replaced by qualified personnel.
• For this purpose, the appliance must
be disconnected from the power
supply.
• When changing a lamp, make sure
that the new lamp does not have a
higher wattage than of the original.
• Before connecting the hood, check
that the voltage indicated on the
rating plate (V) corresponds to the
supply voltage in your home.
51