Hendi 281444 Bedienungsanleitung Seite 9

Programming
This microwave can preset up to 100 programs.
See and follow "User options - 9 Double digit"
session for setting program no. from 10 to 100.
Open the door, then press and hold number "1"
on the number keyboard for about 4 ~ 6 sec-
onds, the buzzer will sound and the display will
show "ProG" to indicate you entered program
mode. Select the time with the '
display will show "00:00", select the requested
time with the number keyboard. After that, se-
lect the power level. Press the power level but-
tons [0%/20% (defrost) /50%/70%], the display
will show the selected power. If you press again
the same power level button, the power will be
back to set 100% power. Also, if no power level
button is set, the power will be default to 100%.
After setting the time, power and press the '
' button to save the program. The display will
show "ProG". Close the door to return to 'ready
mode'. If you want to cancel during program-
ming, press the ' ' button and the oven will
return to the 'door open' mode and the pro-
gram won't be saved.
Double quantity (X2)
This microwave is equipped with a function
to calculate the amount of time needed when
preparing a double quantity of food. Press the
'X2' button followed by the program and the
Below a quick guide how to make a program of
1.25 minutes at 70% power:
1) Open the door and press number button '1'
for 5 seconds, display will show "ProG".
2) Press number button '3', the program will
be saved in "3".
3) Press the number buttons '1' '2' '5' to set the
' button, the cooking time.
4) Press
show "PL7".
5) Press the ' ' button. The program is now
saved under number keyboard '3'.
To overwrite the program repeat the steps
above.
Note: Total programming time is limited to 60
minutes only.
Note: When the cooking time exceeds the max-
imum time the microwave can operate (stand-
ard 60 minutes) three beeps will be sound. This
means you need to adjust the time before the
program can work.
Note: See also = = > Return to factory settings.
microwave will increase the time you preset
and start the process. This function can only
be used in combination with a preset program
mode.
for the power level. The display will
EN
9