Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SR87
■ ■ ■ ■ ■ Scale and slider installation notes
Notes
. Do not turn on the power before installing the scale.
. Install the scale with the opening on the scale unit facing downward. If the opening cannot be turned
downward, it should face horizontally. Never install it facing upward. (Fig. 1)
. Remove off the coating around the tap hole to ground the scale unit using the installation surface contact
with the scale.
. Be aware that the scale will be damaged if slider moved outside the measuring length (ML).
. In environments where coolant can splash directly on the scale, be sure to mount a cover on the scale to
protect the scale from splashing. (Fig. 2)
Fig. 1
Opening facing
downward
(
)
. The slider holders are used to secure the slider in place during transport. They are not guides for installation.
. Do not take off the slider holders, if possible, until immediately before securing the slider.
. Even if the slider holders are removed, the plastic hook provided on the slider allows the slider to
maintain an approximate positional relationship with the scale unit.
. The plastic hook can come off if the slider is forcibly twisted or other excessive force is applied. If the
plastic hook comes off, return the plastic hook back to its original position before performing the
installation. (See Fig. 4.)
Fig. 3
State when Transporting / Securing in Place
Slider holder L
Slider holder R
Fig. 4
Plastic hook
SR87, CH33
Opening facing
Opening
horizontally
facing upward
(
)
(
Removing the slider holder
1. Removing the lock
Turn the right and left slider holder levers in the
counterclockwise direction (position in the illustration).
2. Removing
Slide the slider holder to the outside, and remove from
the scale.
Lever
(Turn to this position)
Plastic hook
Fig. 2
)
Step 1
Step 2
Step 2
Coolant
Step 1
Lever
(Turn to this position)
3
(E)
Werbung
