V2 FLEXY2 Bedienungsanleitung Seite 18

STORING OF THE TRANSMITTERS
• Keep PROG.RX pressed until the led L1 lightens
• Release the push-button, the led switches off and it sends out
a sequence of single flashings for 5 seconds: the number of
short flashings shows the selected channel
• To select the further channels press and release the PROG.RX
push-button within 5 seconds, the led changes type of flashing
according to the following table:
SELECTED FUNCTION
CHANNEL
CHANNEL 1 START
CHANNEL 2 PEDESTRIAN START
CHANNEL 3 STOP
CHANNEL 4 COURTESY LIGHT
FULL ERASING of the TRANSMITTERS
To perform a full erasing of the transmitters stored in memory do
the following:
• Switch off the power supply of the control unit,
• Press and hold pressed the PROG.RX key of the receiver
• At the same time turn on the power supply again. The L1 led
goes on
• Release the PROG.RX key: the led L1 remains on for the
duration of the erasing phase (about 5 seconds)
• When the led L1 turns off the erasing procedure is complete
and the control unit is ready for a new programming
To perform a partial code erasing the PROG2 portable
programmer is required
ROLLING CODE FUNCTION
It is possible to enable and to disable the ROLLING CODE function
(normally disabled)
• Press PROG.RX push-button, holding it for 8 seconds.
• L1 led will switch off after 8 seconds. Release the push-button.
• L1 led starts a sequence of flashing for 5 seconds:
g
Single flashings ROLLING CODE is disabled
g
Double flashings ROLLING CODE is enabled
• To modify the parameters press the PROG.RX push-button
within 5 seconds after the first flashing of the sequence; L1 led
will flash according to the new parameters.
• Choose the channel you want to memorize and within 5
seconds press and hold the push-button of the transmitter.
• The led L1 switches off and it switches on again: this means
that the code has been memorized.
• The device will wait for a further code to memorize for a
maximum time of 5 seconds.
N° Impulses
PROG.RX
1
2
3
4
SUBSITUTIVE TRANSMITTER
The substitutive transmitter, generated only by means of
WINPPCL, allows to replace by radio a transmitter stored in the
receiver.
A single transmission with the specially programmed
SUBSTITUTIVE TX, nearby the receiver, replaces the transmitter
code with the new one.
Repeat the process with all keys of the SUBSTITUTIVE TX.
Example: Memorized TX A transmitter
It is possible to make three replacements maximum per code, so
for TX A you can find:
TX B replaces TX A (TX A is no longer operative)
TX C replaces TX B (TX B is no longer operative)
TX D replaces TX C (TX C is no longer operative)
- 16 -
Flashing
single double
•
• •
triple quadruple
• • •
• • • •