Approach Directions; Operating Distance; Limit Range Monitoring - Ssp Holdx Rl2 Betriebsanleitung

3 .7 Approach directions

Fig. 10: Direction of approach is frontal.
30

3 .8 Operating distance

S
x
Fig. 11: S ecorresponds to S , S , S
x ao n ar
ON (S )
ao
TYPE (S )
n
OFF (S )
ar
Terms acc. to EN IEC 60947-5-3:
S = Assured operating distance ON
ao
S = Typical switching distance
n
S = Assured operating distance OFF
ar
Fig. 12: Operating distance

3 .9 Limit range monitoring

If the actuator is in the limit range of the operating distances, see Section 2.8 – Technical
data, with the corresponding offset values of the sensor, this information is transmitted to a
PLC (output serial OUT Pin 7 (X1) and Pin 8 (X1)) or displayed via the LEDs, see Section 6.1.
S = 18 mm
ar
S = 11 mm
n
S = 6 mm
ao
EN