Residual Risks; Package Contents; Electrical Safety - DeWalt D21620 Handbuch

EN GLI SH
• Do not pour cutting fluid into the reservoir
while it is mounted in the bracket. Do not allow
cutting fluid to enter the drill motor.
• Before use, ensure movable chuck guard
operates properly.
• Ensure that metal chips or resinous residue
cannot lead to blockage of the function.
• In case of jammed cutter disconnect the
machine from the power supply, remove
the reason for the jam before turning on the
machine again.

Residual Risks

In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
– Impairment of hearing .
– Risk of personal injury from flying particles.
– Risk of burns due to accessories becoming hot
during operation.
– Risk of personal injury due to prolonged use.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
DATE CODE POSITION
The Date Code, which also includes the year of
manufacturing, is printed on the rating plate.
Example:
2010 XX XX
Year of Manufacture

Package Contents

The package contains:
1 Magnetic drill press
1 Drill guard
3 Handles
1 Hub
26
1 Safety strap
1 Lubrication system
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. On/Off
b. Magnet switch
c. Motor switch
d. Magnetic stand
e. Feed handle
f. Tool holder
g. Guard
h. Cutting fluid tank
INTENDED USE
Your D21620 magnetic drill press has been
designed for drilling holes in steel construction
surfaces. Do not drill into non-ferrous metal.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This drill press is a professional power tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is designed in class I (grounded)
E
according to EN 61029. Earth wire is required.
WARNING: 115 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E