Connecting Cash Dispensers To Sistore Mx; Interface Configuration - Siemens RCI 0601 Benutzerhandbuch

Connecting cash dispensers to SISTORE MX

10 Connecting cash dispensers to SISTORE MX
10.1

Interface configuration

50
Siemens Building Technologies
Fire Safety & Security Products
Prerequisite:
When connecting cash dispensers to SISTORE MX, one MX Multi-Channel
Box is required for each cash dispenser.
When connecting cash dispensers to SISTORE MX, proceed as follows:
1. Contact the manufacturer of the cash dispenser or your customer for
information on the interface configuration.
Interface configuration: Baud rate, data/stop/parity bit(s).
2. If no information on the CDM interface is available, check the interface using
the logging mechanism.
Open the .ini file.
–
Check the interface parameters under Format (see Section 9.4). See
–
Section 10.1: Schnittstelleneinstellung.
Enter the correct cash dispenser type. If no type is entered, the interface
–
will be ignored.
The following interface configurations are the most commonly used:
SNI CDM (for SNI, SNI_DREBA and SNI_PBM)
2400 baud, 8 D-bits, 1 stop bit, none parity
9600 baud, 8 D-bits, 1 stop bit, none parity
IBM and NCR CDM
1200 baud, 7 D-bits, 1 stop bit, odd parity
9600 baud, 8 D-bits, 1 stop bit, none parity
ASCOM CDM
9600 baud, 7 D-bits, 1 stop bit, odd parity
06.2006