Holzmann D460FXL Originalbetriebsanleitung Seite 22

OPERATION INSTRUCTIONS
Belt: You need only to move the spindle enough to slide a new belt on.
Spindle: You must knock the spindle completely out through both bearings.
Bearings: After removal of the spindle, completely - knock out the bearings from the inside
of the headstock. This is best accomplished by inserting a long rod or screwdriver through one
bearing inside the headstock toward the opposite bearing. Tap firmly to remove the bearing
from the casting. Do the same for the second bearing. Please be aware not to damage the re-
tainers (#13) when tapping out the bearing. Reassemble the new bearings by tapping them
into place from the outside. Replace the spindle.
Note: You may have to loosen the ratchet handle (PARTS #44, #45,#46) to reinstall the
spindle pulley (#52), spindle collar (#3), and belt (#53). Reinstall the hand wheel and set
screws. DO NOT tighten the hand wheel against the bearings. Tighten the pulley set screw
and close the access door.
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at Seite 22
Drechselbank / wood turning lathe D460FXL