Special Safety Instructions For D460Fxl - Holzmann D460FXL Originalbetriebsanleitung

the power plug after leaving the machine.
22. Never attempt any operation or adjustment if procedure is not understood.
23. Keep fingers away from revolving parts and cutting tools while in operation.
24. Never force cutting action.
25. Never perform an abnormal or little used operation without study and use of adequate blocks, jigs
stops, fixtures ECT.
26. Use of shop manual such as "machinery's handbook" or similar is recommended for cutting speeds
feeds and operation detail.
27. Do not remove drive cover while machine is in operation. Make sure it is always closed.
28. Always remove chuck key, even when machine is not in operation.
29. Do not attempt to adjust or remove tools when in operation.
30. Always keep cutters sharp.
31. Never use in an explosive atmosphere or where a spark could ignite a fire.
32. Always use identical replacement parts when servicing.
WARNING: Do allow familiarity (gained from frequent use of your lathe) to become com-
monplace. A careless fraction of a second can allow for sever injury.
We want to point out that when working with machine tools are always a residual risk remains
that is not mentioned in the above safety precautions. There is always the utmost care when
working with such machines. Especially for machine operators already experienced the acci-
dent risk increases by routine.

12.4 Special safety instructions for D460FXL

1. For your own safety, read the entire instruction manual before operating the lathe.
2. ALWAYS wear eye protection.
3. Do not wear gloves, necktie, or loose clothing.
4. Tighten all locks before operating.
5. Do not mount a split workpiece.
6. Use the lowest speed when starting a new workpiece.
7. Read the warning label attached to the wood lathe.
8. When turning a workpiece, always rough the wood to round form at slow speed. If the lathe is run so
fast that it vibrates, there is a risk that the workpiece will be thrown or the tool jerked from your
hands.
9. Always rotate the workpiece by hand before turning on the motor. If the workpiece strikes the tool
rest, it could split and be thrown out of the lathe.
10. Do not allow the turning tools to bite into the wood. The wood could split or be thrown from the
lathe.
11. Always position the tool rest above the centerline of the lathe when shaping a piece of stock.
12. Do not operate the lathe if it is rotating in the wrong direction. The workpiece must always be rotat-
ing toward you.
13. Before attaching a workpiece to the faceplate, always rough in out to make it as round as possible.
This minimizes the vibrations while the piece is being turned. Always fasten the workpiece securely
to the faceplate. Failure to do so could result in the workpiece being thrown from the lathe.
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
SAFETY GUIDELINES
Drechselbank / wood turning lathe
Seite 20
D460FXL