Silvercrest SPBP 4 A1 Bedienungs- Und Sicherheitshinweise Seite 27

To charge the power bank
with an output voltage of 5 V and an output current of
at least 3 A.
ATTENTION! Due the high power consumptions, the
power bank must not be charged from a PC or notebook.
Connect the USB type A to USB type C cable
the USB-C Input
Connect the other end of the USB type A to USB type C
cable (USB Type A) to a USB power supply (not in-
7
cluded in the scope of delivery) (see fig. B).
The current battery status is shown by LED indicator
LED indicator
1 LED flash
1 LED light up, 1 LED flash
2 LED light up, 1 LED flash
3 LED light up, 1 LED flash
4 LED light up
* This is approx percentage of power bank capacity but not
actual measurement.
The required charging time for the power bank depends
on the charging source and its output power. Fully charged
this power bank by using 5 V / 3 A charging source approx.
6 hours.
ATTENTION! Do not connect any device to the power
bank for charging while the power bank itself is charging.
Remove the charging cable from the Powerbank when it
is fully charged.
6
of the power bank
3
status
5
0‒25 %
25‒50 %
50‒75 %
75‒100 %
100 %
only use power supplies
.
6
Power bank
capacity level*
with
7
:
5
GB/IE 27