Modster Easy Trainer 600 Bedienungsanleitung Seite 19

Manual
5. Centering of the Control Surface
When the transmitter is switched on and the flight battery is connected to the controller (and installed in the battery box), it is now possible
to connect the control wires to the rudder and treble control surfaces and to center the surfaces accordingly.
Rudder
centered
Make sure that the rudder / elevator is properly centered as shown in the picture above/below.
Elevator
centered
If the rudder is angled off to the right or left, adjust the push rod by
its arc-shaped section slightly, making sure the rudder is properly
centered.
www.modster.at
MODSTER Easy Trainer 600
Rudder
not
centered
Elevator
not
centered
If the elevator is angled off to a lower or upper position, adjust the
push rod by its arc-shaped section slightly, making sure the rudder is
properly centered.
19