Moving The Appliance; Aligning The Appliance - Haier HW80-B14979 Gebrauchsanleitung

10-Installation
10-4
S1
S2
10-5
I1
4. Fill the 6 left holes with blanking plugs (Fig. 10-6).
Note: Keep in safe place
Keep all parts of the transport protection in a safe place for later use. Whenever the ap-

10.4 Moving the appliance

If the machine is to be moved to a distant location, replace the transportation bolts removed
before installation to prevent damage: The assembly takes place in reverse order.
10-7
26
2. Remove the 10 screws (R1 - R10) from lower back
R5-R10
R1-R4
3. Pull out the 2 i
I2

10.5 Aligning the appliance

Adjust all feet (Fig. 10-7) to achieve a complete level
position. This will minimize vibrations and thus noise
during use. It will also reduce wear and tear. We recom-
mend to use a spirit level for adjustment. Floor should
be as stable and flat as possible.
1. Loose the locknut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten lock ut (1) against the housing.
reinforcement. take out reinforcements (S1 and
S2) from the machine(Fig. 10-4). *Only HW90/
100/120-B...
ron bars I1 and I2 (Fig. 10-5).
*Only HW90/100/120-B...
10-6
EN