Adjusting The Feet - Haier HW80-BD1626 Bedienungsanleitung

Troubleshooting
Drainage failure. Pump filter is blocked.
Drain hose end is higher than
100 cm above floor level.
Drain hose is blocked.
Strong vibration Machine load is not correct..
while spinning. Washing machine is located
on an uneven surface or is
not levelled.
Not all transportation bolts
have been removed.
Operation stops Water or electric failure.
before completing
wash cycle.
Operation stops No displayed "error code"?
for a period of time. Programme performs
soaking cycle?
Programme break down.
Excessive foam Detergent is not a appropriate.
floats drum and/or
detergent drawer. Excessive use of detergent.
Automatic adjustment Washing programme
of washing time. duration will be adjusted.
Spinning fails. Unbalance of laundry.
22
Clean pump filter.
Make sure that drain hose
is properly installed.
Unblock drain hose.
Adapt amount of laundry.
Make sure that washing
machine is on an even sur-
face and levelled.
Remove all transportation
bolts.
Check power
and water supply.
Activate display - see ".display".
Touch "Start/Pause" to resume.
If it seems appropriate
cancel operation.
Check detergent
recommendations.
Reduce amount of detergent
This is normal and doesn't
affect functionality.
Check machine load and
laundry and run a spinning
programme again.
23
Preparation
Remove all packaging material including polystyrene base.
While opening the package, water drops may be seen on
plastic bag and porthole. This normal phenomenon results
from water tests in the factory.
Dismantle the transportation bolts
The transportation bolts are designed for clamping anti-
vibration components inside the appliance during transpor-
tation.
Remove the back cover.
Remove bolts on the rear side and take out
from inner side of the machine.
Replace back cover by inserting it in the two gaps its con-
vexity is facing outside
Fill left holes with blanking plugs.

Adjusting the feet

Adjust all feets to achieve a complete level position.This will
minimize vibrations and thus noise during use. It will also
reduce wear and tear. We recommend to use a spirit level
for adjustment. Floor should be as stable and flat as possible.
Installation
plastic spacers