Care And Cleaning; Cleaning The Detergent Drawer; Cleaning The Machine; Environmental Information - Haier HW70-B14266 Gebrauchsanleitung

Care and cleaning

Cleaning the detergent drawer

2
Clean the drawer from detergent residues regularly Pull out
the drawer until it stops (1) and press the release button (2)
to remove the drawer. Then fl ush the drawer with water
until it is clean and insert the drawer back in the appliance.
1

Cleaning the machine

Cotton M Daily Wash
加速洗 Speed up 90 1400 Synthetic Ultra White
超净洗 Intense 70 60 1200 1000 剩余时间 预约时间 M
Soak 高水位 40 800 Mix M Express 15'
夜 洗 Anti crease 30 600 Wool Baby Care
防皱浸泡 20 400 Underwear Delicate
Rinse 加漂洗 1 2 3 常温 不甩干 Sport Hand Wash
Function Selection Temp. Spin 负载 M emo Delay Jeans Spin/Drain
Hygienic Self Clean
Unplug the machine during cleaning and maintenace. Use a
soft cloth with soap liquid to clean the machine case and
rubber components. Do not use organic chemicals or corro-
sive solvents.
General information and tips:
After each installation or longer downtime run at fi rst pro-
"
gramme Self Clean" with no load and added detergent
in washing agent compartment (2) to remove possibly
corruptive residues.

Environmental information

To achieve best use of energy, water, detergent and time
you should use the recommended maximum load size.
Do not exceed indicated chemical dosages.
Choose always lowest washing temperature.
Modern detergents are cleaning effi ciently below 60°C.
Only due to heavy soil raise accordingly default settings.
Using afterwards a domestic dryer max. spinning speed is
recommended.
16 17
Pump fi lter
Please check the pump fi lter for instance if the appliance
- doesn´t drain the water,
- doesn´t spin,
- cause unusual noise while running.
Warning!
Scalding Risk! Water in the pump fi lter can be very hot! Before any
action please ensure water has cooled down.
1. Turn off and unplug the machine.
2. Open service fl ap. You can either use a coin or a
screwdriver.
3. Provide a fl at container to catch leach water.
There could be bigger amounts!
4. Pull the drainhose out and hold its end above the
container.
5. Take the sealing plug out of the drainhose.
6. After complete drainage, unscrew and remove counter
clockwise the pump fi lter.
7. Remove contaminants and dirt.
8. Clean carefully pump fi lter, e.g. using running water.
9. Refi x it thoroughly.
10. Close drainhose and push it back into the machine.
11. Close service fl ap
Warning!
Pump fi lter sealing has to be clean and unhurt.
If the lid is not full tightened, water can escape.
Care and cleaning