Moving The Appliance; Adjusting The Feet; Drain Hose; Installation - Haier HW80-B14266A Benutzerhandbuch

24
80 - 100 cm
6.
6. Replace back cover by inserting it in the two gaps its
convexity is facing out.
7. Fill left holes with blanking plugs.

Moving the appliance

If the machine is to be moved to a distant location, replace
the transportation bolts removed before installation to
prevent damage.
1. Remove the blanking plugs.
7.
2. Remove the back cover
3. Insert the plastic spacers and the transportation bolts.
4. Tighten the bolts with a spanner.
5. Replace the back cover.

Adjusting the feet

Adjust all feets to achieve a complete level position.This will
minimize vibrations and thus noise during use. It will also
reduce wear and tear. We recommend to use a spirit level
for adjustment. Floor should be as stable and flat as possi-
ble.

Drain hose

Drainage could be installed in different ways. Nevertheless,
level of drain hose has to reach at one point 80-100 cm.
Do not twist, kink or jam the drain hose. If possible keep
always drain hose fixed to the clip at the appliance back.
1. Drain hose to sink
Use the drain hose bracket to keep drain hose end
retained and out of any water level.
Fix the bracket sufficiently to avoid dropping down
due to operational movements.
2. Drain hose to sink connection
The connection to the spigot of the water trap assebly
below the sink must be secure. Ensure a proper
height above ground to avoid drainage problems or
self-syphoning.

Installation