Speaker Setup For Dcs-202K - Pioneer DCS-202K Bedienungsanleitung

18 Installation

Speaker Setup for DCS-202K

Preparing the speakers
1. Attach the non-skid pads to the base of
each speaker.
For speaker stand bases:
Use the supplied adhesive to attach four
middle pads to the base (bottom) of each
speaker stand base.
3
For subwoofer:
Use the supplied adhesive to attach four
large pads to the base of subwoofer.
For center speaker:
Use the supplied adhesive to attach four
small pads to the base of center speaker.
2. Connect the wires to the player.
Connect the white wire with gray line into
(+) side and the other wire into (–) side. To
connect the cable to the player, press each
plastic inger pad to open the connection
terminal. Insert the wire and release the
inger pad.
CAUTION
• Do not connect any speakers other than those
supplied to this system.
• Do not connect the supplied speakers to any
ampliier other than the one supplied with this
system. Connection to any other ampliier may
result in malfunction or ire.