Additional Safety Rules - Panasonic EY6903 Bedienungsanleitung

Read the Safety Instructions booklet
and the following before using.
. ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
2) When drilling or driving into walls, floors,
etc., "live" electrical wires may be encoun-
tered. DO NOT TOUCH THE CHUCK
OR ANY FRONT METAL PARTS OF
THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock in
case you drill or drive into a "live" wire.
3) If the bit becomes jammed, immediately
turn the main switch off to prevent an over-
load, which can damage the battery pack
or motor.
Use reverse motion to loosen jammed bits.
4) Do NOT operate the Forward/Reverse
lever when the main switch is on. The
battery will discharge rapidly and damage
to the unit may occur.
5) During charging, the charger may be-
come slightly warm. This is normal. Do
NOT charge the battery for a long period.
6) Use only a dry, soft cloth to wipe the unit.
Do NOT use a damp cloth, thinner, ben-
zine, or other volatile solvents for cleaning.
7) When storing or carrying the tool, set the
Forward/Reverse lever to the center posi-
tion (switch lock).
8) Do not strain the tool by holding the
speed control trigger halfway (speed con-
trol mode) so that the motor stops.
9) Wear ear protectors when using the tool
for extended periods.
10) The appliance is not intended for use by
young children or infirm persons without
supervision.
11) Young children should be supervised to
ensure that they do not play with the appli-
ance.
. ASSEMBLY
Attaching or removing bit
Note:
When attaching or removing a bit,
disconnect battery pack from tool
or place the switch in the center
position (switch lock).
This tool is equipped with a keyless
drill chuck.
1. Attachment
Insert the bit and turn the Lock col-
lar clockwise (looking from the front)
to tighten firmly.
Slide the Lock collar to LOCK side
until it snaps.
2. Removal
Slide the Lock collar to FREE side.
Turn the Lock collar counterclock-
wise (looking from the front), then
remove the bit.
Note:
If excessive play occurs in the
chuck,
and tighten the chuck by turning
clockwise,
by unscrewing the Lock collar and
tighten the screw (left-handed
screw) with a screwdriver by turn-
ing it counterclockwise (viewed
from the front).
Attaching or removing battery
pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
- 4 -
Lock collar
LOCK
Lock collar
FREE
secure the drill in place
open the chuck jaws