Specifications; Specific Safety Rules - Makita BHR241 Betriebsanleitung

ENGLISH
1. Red part
2. Button
3. Battery cartridge
4. Switch trigger
5. Reversing switch lever
6. Lock button
7. Rotation with hammering
8. Action mode changing knob
9. Rotation only
10. Hammering only
11. Grip base

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to rotary
hammer safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool. Loss
of control can cause personal injury.
3. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
Explanation of general view
12. Side grip
13. Loosen
14. Tighten
15. Teeth
16. Protrusion
17. Bit shank
18. Bit grease
19. Bit
20. Chuck cover
21. O symbol
22. Depth gauge
Model
Concrete
Steel
Wood
-1
)
Net weight
easily, causing a breakdown or accident. Check
ENE043-1
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
GEB007-2
8. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high
locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
13. Do not touch the bit or parts close to the bit
immediately after operation; they may be
extremely hot and could burn your skin.
14. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
23. Dust cup
24. Blow-out bulb
25. Chuck adapter
26. Keyless drill chuck
27. Sleeve
28. Ring
29. Limit mark
30. Screwdriver
31. Brush holder cap
BHR241
20 mm
13 mm
26 mm
0 - 1,100
0 - 4,000
417 mm
3.2 kg
D.C. 18 V
5