Axkid Minikid 3 Premium Bedienungsanleitung Seite 12

Thank you for choosing Axkid Minikid 3
Read this instruction manual before installing Axkid Minikid 3 car seat in your vehicle.
For more information and installation videos visit www.axkid.com.
Axkid Minikid 3 is a rear-facing car seat approved for children with
a height between 61-125 cm, ≤36 kg
Axkid Minikid 3 is suitable for use from approximately six months of age, or from when your child can sit up unsupported.
This is an integral Specific vehicle Belted Enhanced Child Restraint System. It is approved according to UN Regulation No.
129, for use in compatible vehicle seating positions as indicated by the vehicle list. If in doubt, consult either the Enhanced
Child Restraint System manufacturer (www.axkid.com) or the retailer.
Important information
To maximize your child' s safety, it is important that you keep the following in mind:
• Always follow the instructions in this manual. An incorrect installation may seriously affect the safety for your child. If in doubt, contact
your retailer who can demonstrate a correct installation.
• Keep this instruction manual for future reference. If manual is lost, you can find it online at www.axkid.com
• Do not use Axkid Minikid 3 car seat in a seating position where an active frontal airbag is fitted. If you still wish to install Axkid Minikid 3 car
seat in this location the airbag must be switched off according to the vehicle manufacturers instructions.
• Should you have an accident, no matter how small, your car seat should always be replaced. It may have damage that is not visible and
could seriously affect the safety of your child. For this reason, Axkid does not recommend purchasing secondhand car seats.
• If Axkid Minikid 3 car seat has been exposed to direct sunlight, make sure the car seat is not too hot before installing your child.
• Never leave your child unattended in the vehicle.
• Ensure that any luggage or loose objects are secured in your vehicle as they may cause injuries to passengers in the event of an ac-
cident.
• Ensure that Axkid Minikid 3 car seat is installed in a way where no parts become trapped by movable seats, car doors, etc.
• If you are using lower tether anchorage straps, make sure they are installed in a way where they don't interfere with the movement of
any vehicle seat.
• Axkid Minikid 3 car seat may only be installed rear-facing.
• Always make sure that the harness is adjusted to correctly fit your child' s body. The harness is adjusted by moving the head support.
• Make sure that the child' s back is pushed against the car seat when restraining your child with the harness.
• Always make sure that the harness is firmly tightened against your child and that the buckle is completely locked, you should not be able
to pinch the straps.
• Make sure there is no twist in the harness.
• Always make sure the support leg is in its correct position and that is has contact with the vehicle floor. The support leg is a very impor-
tant safety feature designed to maximise your child' s safety in an accident.
• Do not attempt to disassemble or modify any part of Axkid Minikid 3 car seat. The warranty and the safety performance of Axkid the car
seat could be affected if doing so.
• Never use Axkid Minikid 3 car seat without the textile cover. The seat textile cover is a safety feature and may only be replaced with an
Axkid original seat textile cover.
• Read the vehicle handbook and the vehicle list at www.axkid.com to find which seating positions are suitable for this car seat
• Axkid recommends to always use a seat protection to protect your vehicle seat from scratches and dirt.
• If you have any doubts, contact the retailer where the car seat was purchased or contact info@axkid.com
12