Possible Causes Of Failure - EINHELL TE-AC 36/8 Li OF Set Originalbetriebsanleitung

9. Possible causes of failure

Problem
The compressor
does not start.
The compressor
starts but there is no
pressure.
The compressor
starts, pressure is
shown on the pres-
sure gauge, but the
tools do not start.
Anl_TE_AC_36_8_Li_OF_Set_SPK13.indb 21 Anl_TE_AC_36_8_Li_OF_Set_SPK13.indb 21
GB
Cause
1. No power supply
2. The outside temperature is too low
3. The motor is overheated
1. The non-return valve has a leak.
2. The seals are damaged.
1. Loose hose connections.
2. Leak in a quick-lock coupling.
- 21 -
Solution
1. Check the batteries
2. Do not use at an outside tempera-
ture below +5° C.
3. Allow the motor to cool down. If
necessary, remedy the cause of the
overheating.
1. Replace the non-return valve.
2. Check the seals and have any da-
maged seals replaced by a service
center.
1. Check the compressed air hose
and tools and replace if necessary.
2. Check the quick-lock coupling and
replace if necessary.
28.02.2022 08:08:53 28.02.2022 08:08:53