Operation - EINHELL TE-AC 36/8 Li OF Set Originalbetriebsanleitung

Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The machine's operating time depends on the
battery with the lower charge level. The two bat-
teries must always be fully charged before use.
Close the battery cover by swinging it down, and
make sure that it latches in place correctly.
5.2 Fitting the batteries (Fig. 8a/b)
Swing open the battery cover (Item 11) as shown
in Fig. 8a by pressing (1) and pulling outwards (2).
Then insert the two batteries (c) in the mounts as
shown in Fig. 8b and close the cover.
5.3 Battery capacity indicator (Fig. 10)
Press the button for the battery capacity indicator
(a). The battery capacity indicator (d) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
Anl_TE_AC_36_8_Li_OF_Set_SPK13.indb 18 Anl_TE_AC_36_8_Li_OF_Set_SPK13.indb 18
GB

6. Operation

6.1 On/Off switch (4)
To switch on the equipment, set the On/Off switch
(4) to position 1.
To switch off the equipment, move the On/Off
switch (4) to position 0.
6.2 Compressed air hose with quick-lock
coupling (3)
Connecting:
Insert the nipple of the air tool into the quick-lock
coupling, the sleeve will spring forward automa-
tically.
Disconnecting:
Pull back the sleeve and remove the tool. Cauti-
on! When releasing the quick-lock coupling,
be sure to hold the coupling piece to protect
yourself against injury from the rebounding
hose.
6.3 Tire pressure gauge with adapters (Fig. 2)
Working pressure in bar: 0-8
Range of applications:
The tire pressure gauge allows you to infl ate tires
easily and exactly. Use the pressure gauge to
check the tire pressure. If the tire pressure is too
high, you can reduce the pressure with the integ-
rated relief valve (e).
After fi lling with air, please check the set tire
pressure with a calibrated gauge, for example at a
petrol station.
The tire pressure gauge comes with a valve adap-
ter for car tire valves.
You can also fi ll other valve types by using the
supplied adapters.
Using the equipment as a blow-out pistol
(Fig. 3)
To use the tire pressure gauge as a blow-out
pistol you must fi rst unscrew and remove the
hose with the valve adapter for care tires. Now the
blow-out adapter (7) can be screwed to the tire
pressure gauge.
Range of applications:
For cleaning and blowing out hollow spaces or
hard-to-reach areas, as well as for cleaning soiled
- 18 -
28.02.2022 08:08:52 28.02.2022 08:08:52