Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TE-AC 36/8 Li OF Set Originalbetriebsanleitung

equipment. The infi nitely variable trigger lever al-
lows an exact dosing of compressed air.
Do not exceed the maximum permissible opera-
ting pressure of 8 bar (also shown on the back of
the tire pressure gauge).
6.4 Instructions for the adapter set
For information on the correct use of the adapters
for the various valves, please refer to the following
overview (see Fig. 7 which shows how to connect
the adapter to the compressor).
•
Ball needle (Figure 4)
•
Range of applications: For inflating balls. The
ball needle can be used to inflate a variety of
different balls.
TIP: To avoid damaging the valve, moisten
the needle slightly before inserting it.
•
Valve adapter (Figure 5)
Range of applications: For Dunlop and Presta
cycle tire valves.
This valve adapter is designed for inflating
cycle tires.
•
Conical universal adapter (Fig. 6)
Range of applications: The universal adapter
can be used for inflating airbeds and other
similar items.
Danger! Never direct the jet of compressed air at
yourself or at any other persons or animals.
Caution! Infl ating objects to above the recom-
mended pressure level may cause damage to the
objects or harm to bystanders!
6.5 What to do in case of an abnormal/emer-
gency situation
1. Stop the operation
2. Switch off the equipment.
3. Pull the power plug
6.6 After using
1. Switch off the equipment.
2. Take out the batteries.
3. Remove all accessories from the equipment
such as, e.g. hose, tire pressure gauge, etc.
4. If the equipment is going to be cleaned or
repaired, allow it to cool down fi rst.
5. Check the equipment for signs of damage.
Anl_TE_AC_36_8_Li_OF_Set_SPK13.indb 19 Anl_TE_AC_36_8_Li_OF_Set_SPK13.indb 19
GB
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Remove the rechargeable batteries before
doing any cleaning and maintenance work.
Danger!
Wait until the compressor has completely
cooled down. Risk of burns!
Danger!
After use, always switch off the equipment
immediately and pull out the rechargeable
batteries.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
You must disconnect the hose and any
spraying tools from the compressor before
cleaning. Do not clean the compressor with
water, solvents or the like.
7.2 Storage
Danger!
Pull out the rechargeable batteries and ventilate
the equipment and all connected pneumatic tools.
Switch off the compressor and make sure that it is
secured in such a way that it cannot be started up
again by any unauthorized person.
Danger!
Store the compressor only in a dry location
which is not accessible to unauthorized per-
sons. Always store upright, never tilted!
- 19 -
28.02.2022 08:08:52 28.02.2022 08:08:52