SUBLIMED actiTENS Gebrauchsanleitung Seite 79

NB: If you use the
actiTENS
go into error mode for safety. If this happens, wait for the device to cool completely. It is
normal for the device to become warm during a session, but the heat will not cause injury or
damage. Under normal conditions, the
• The will not start
actiTENS
POSSIBLE CAUSE
1- The battery is discharged
2. error
actiTENS
• La stimulation semble être différente ou moins agréable que précédemment
POSSIBLE CAUSE
1- The electrodes are not correctly
positioned
2- The intensity is wrong
3- The electrodes are damaged
• Slight discharge on touching the electrodes
POSSIBLE CAUSE
A session was in progress when
you touched the electrodes
• The becomes disconnected
actiTENS
• Once the programme is launched, disconnection does not affect the running of the actiTENS.
The Bluetooth signal range may be affected by the charge level of your telephone or your
actiTENS. Some telephones are designed to cut the connection more quickly to save the
battery. To reconnect your actiTENS, go to the
actiTENS"
• The neurostimulator and its components are guaranteed under normal conditions of use.
at its maximum setting for several hours, it may overheat and
can reach a temperature of 42.3°C.
actiTENS
Recharge the device.
Leave the device for about fifteen minutes, then switch
it back on. If the error recurs, contact Customer care.
Change the position of the electrodes while not in a
session by putting your session on Pause from the app.
Set the intensity from the app so that the sensation
is not disagreeable. The intensity necessary can vary
from one session to another
Check the condition of the electrodes: wear,
cleanliness, expiry date. Replace or clean them.
Always end or pause a session before handling the
electrodes.
SOLUTION
SOLUTION
SOLUTION
menu and press "Detect an
actiTENS
79