Connecting The Antelope.2C-Booster And Antelope.8C-Booster To The Antelope.app Via Bluetooth; Starting The Stimulation; Regulating Stimulation - Beurer ANTELOPE TECHWEAR Benutzerhandbuch

8.5 Connecting the ANTELOPE.2C-BOOSTER and
ANTELOPE.8C-BOOSTER to the ANTELOPE.APP via Bluetooth
NOTE
The ANTELOPE.APP must first be downloaded via the App Store
or Google Play Store before connecting.
1. Hold the [+] button on the BOOSTER until the blue shining
LED begins to flash. This indicates the BOOSTER is searching
for a compatible device via Bluetooth.
2. Switch the Bluetooth ON from your compatible device
3. Open the ANTELOPE.APP on your device and select the "con-
nect" tab. Your Booster appears on this page. Tap on the
Booster to connect and select the options in the fields to
continue.
NOTE
• After switching on the BOOSTER and before connecting to a
Bluetooth device, the BOOSTER will display a constant green
LED.
• After connecting to the APP via Bluetooth, the LED will
change to a constant blue light.
•
DANGER
If the connection to a Bluetooth device is interrupted for sev-
eral minutes, the BOOSTER DOES NOT switch off automatically.
If a connection between a Bluetooth device and the BOOSTER
is interrupted, immediately disconnect the connection between
BOOSTER and Baseplate. (see 8.7.1)
ANTELOPE - part of the Beurer group - BEURER GmbH

8.6 Starting the Stimulation

NOTE
Stimulation can only be started from the ANTELOPE.APP. App
and BOOSTER must be connected before.
1. Tap the EMS tab of the ANTELOPE.APP and select a program.
NOTE
The duration of each program can be adjusted.
2. Tap the "start" button at the bottom of the screen to begin
stimulation.

8.7 Regulating Stimulation

• Once the stimulation has been started it can be regulated us-
ing the ANTELOPE.APP and/or directly from the ANTELOPE.
BOOSTER.
• Pressing the [+] on the EMS tab of the ANTELOPE.APP OR on
the BOOSTER, will increase the intensity by one unit on all
channels.
• Pressing the [-] on the EMS tab of the ANTELOPE.APP OR
on the BOOSTER, will reduce the intensity by one unit on all
channels.
DANGER
If stimulation cannot be felt at an intensity of 25%, SWITCH OFF
the BOOSTER and APPLY ANTELOPE. SPRAY directly to the elec-
trodes in the textile. Then restart the ANTELOPE.APP and make
36