Sumitomo PARAMAX 9000 Betriebsanleitung Seite 55

6.2.2 Feather Key Connection
Size 9060 - 9085
The end of the hollow shaft is fitted with a pressure plate (d). The pressure plate is required for
assembling, securing and dismantling the unit.
Fitting Instructions (Fig. 19)
1. Lubricate the shaft surface (3) with molybdenum
disulphite grease.
2. Turn the nuts (b) and push the gearbox onto the
output shaft. To do this, use washers if necessary.
Securing (Fig. 20)
1. After fitting the gearbox onto the shaft tighten
the screw (f ). (The screw (f ) is not included in the
gearbox delivery schedule).
2. Protect the opening with the cover (g.
Dismantling (Fig. 21)
1. Remove the pressure plate (d), fit the bolt (n)
and replace the ring (d). Attach bolt (J) to ring (d)
and turn bolt (J) to disconnect the hollow shaft
from the input shaft.
See Table 13 for suitable bolt sizes.
Special Cases (Fig.22)
1. If the shaft to be driven (Fig. 11) doesn't have
a shoulder, its seating must be secured with
a spacer ring when assembling. (The spacer
ring (h) is not included in the gearbox delivery
schedule).
54
PX_DEU_ENG_06_2009_999345
PARAMAX 9000 Operation Manual
Fig. 22 Special cases (input shaft without shoulder)
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com Phone +49 (0) 8136 66 0
( e )
Fig. 19 Mounting
Fig. 30 Securing
( n )
Fi 2
Fig. 21 Dismantling
( h)
Cyclostraße 92
85229 Markt Indersdorf
( ) d
( b)
( a )
( f)
( g )
d ( )
( J )
( f)
( g )