Sumitomo PARAMAX 9000 Betriebsanleitung Seite 71

Recommended Lubricants - Grease
Tab. 26
Ambient temperature °C
-10 to +50
Do not use any Type of Lubricants other than those Listed in Table 26.
Topping up with grease (see Fig. 31 below and Figs. 29 and 30 on p. 27)
Drain the old lubricant through the drain screw and during operation top up via the grease nipple. (If
you top up the lubricant when the machine is not operating this may lead to insufficient lubrication).
After topping up let the unit run for 10 minutes and then tighten the drain screw.
Do not use too much grease as this can lead to overheating and leaks.
Never top up with more than the specified amount or extend the lubrication intervals.
Please note: Before starting up fill up with grease and top up regularly. If the machine is not sufficiently
lubricated this could cause excessive wear, increased noise and/or burning.
Parts Subject to Wear and Tear:
If the following parts are replaced after an operating time of 3 - 5 years the service life can be extended
regardless of the operating condition:
Bearings, oil gaskets, nilos rings, adjustment rings, feather keys, spacer washers, gaskets, plugs,
inspection glasses
Check shafts and gear wheels and replace if damaged.
For other parts replace depending on how worn they are.
70
PX_DEU_ENG_06_2009_999345
Open bearings
E, B type insulation
Shell oil
ESSO UNIREX 2
Bearing cover
Bearing cover
Open bearing
Open bearing
Bearing cover Bracket
Motor shaft Motor shaft
Fig.31
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com Phone +49 (0) 8136 66 0
PARAMAX 9000 Operation Manual
F type insulation
DARINA GREASE 2
Grease nipples
Grease nipple
Drain Outlet
Cyclostraße 92
85229 Markt Indersdorf