Installation Angle - Sumitomo PARAMAX 9000 Betriebsanleitung

PARAMAX gear motors or gearboxes must not be used for purposes other than those specified on
the rating plate or in the manufacturer's documentation. This could lead to electric shocks, injuries or
damage to the equipment.
No inflammable objects must be placed near the unit to avoid the risk of fire.
No objects that restrict ventilation must be put near the gear motor or the gearbox. Insufficient
ventilation can cause excessive heat build-up that may result in burns or fire.
Do not tread on the gear motor or gearbox or hang on it because this could lead to injury.
Do not touch the shaft end of the gear motor or the gearbox, the internal gearing or the edges of the
motor fan with bare hands because this could lead to injury.
If the unit is used to make foodstuffs where there is a risk of oil contamination, an oil tray or similar
device must be installed to catch leaking oil in the event of the equipment breaking down or failing.
Products can be contaminated by leaking oil.

4.3 Installation Angle

If the unit has been manufactured to be installed at an angle, the installation angle in the specifications
must be observed exactly.
As far as possible do not remove the motor eyebolt. But if the eyebolt has to be removed insert a bolt
into the thread hole or take other action to prevent water getting into the motor.
1
0
Fig. 3
48
PX_DEU_ENG_06_2009_999345
PARAMAX 9000 Operation Manual
E-Mail: marktind@sce-cyclo.com
www.sumitomodriveeurope.com Phone +49 (0) 8136 66 0
0.3
Cyclostraße 92
85229 Markt Indersdorf