Emerio PAC-127560 Bedienungsanleitung Seite 13

13. Drainage
In case of full water alarm and users need to drain the water to the working level or drain the water in the
water tank, please follow the steps below to drain the water in the internal water tank of the machine.
1) Unscrew the water outlet knob at the back of the appliance, tighten one end of the Water inlet /
outlet hose to the drain hole, and connect the other end to the water collecting container or floor
drain.
2) Insert the power plug into the power socket and press the power button on the control panel.
3) Press the drainage button, a voice prompt will be heard. Continue to press and hold the drainage
button for more than 3 seconds, the system will automatically start the water pump for drainage.
4) If the water level is above the working level, the drainage will stop when it reaches the working level.
If it is necessary to drain the water in the water tank, repeat step (3) to continue the drainage until it
is drained.
5) After the completion of drainage, the drainage pump will automatically shut down.
6) Remove the Water inlet / outlet hose and screw back the water outlet knob.
Important:

After switching the mode, the compressor may enter the protection state. You must wait for 3 minutes
before the compressor can operate normally.

Observe the energy bar to check the status of the remaining stored energy. If the energy bar runs out or
the low temperature indicator / high temperature indicator illuminate, please perform the heat storage /
cold storage.
Notice:

Once the room temperature reaches to the set temperature, the unit will automatically stop and restart
(according to the room temperature with a temperature difference of 2 degrees).
Wi-Fi CONNECTION GUIDE (The guide for the APP may not be updated regularly due to software version
upgrade or other reasons. This instruction is used as a guide only. Below mobile phone interface uses
English version in iOS as an example.):
1. Search "Tuya Smart" in App Store (for iOS) or Google play (for Android) to download the application.
2. Sign up or log in to your account on the APP. Tap the "+" at top right corner or button "Add Device" to add
your device. (Fig.1)
3. Find "Large home appliances" and tap the icon "Portable Air Conditioner (BLE+Wi-Fi)". (Fig.2)
Press and hold the power button on the control panel of the machine for 5 seconds until the Wi-Fi
indicator flashes quickly.
4. Tap "Next" on Fig.3. Continue to tap "Blinking or breathing rapidly" on Fig.4.
You will get the prompt that asks you to use the 2.4 GHz Wi-Fi network. Note that the 5 GHz Wi-Fi is not
supported by this application. Enter your Wi-Fi password and tap "Next". (Fig.5)
5. Wait until you get Fig.6 and then tap "Done" at the top right corner.
6. Now you can operate your device in the control interface. Tap buttons to set your appliance.
- 12 -