Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10. When the water temperature is 18 degrees or below,
please do not inflow or drain water. (The water tank
temperature will be shown on the digital display under
cold storage or heat storage function, and on the App
control interface.)
Special Remind
1. During cold storage, please open doors and windows for
ventilation.
2. After switching the mode, the compressor may enter the
protection state. You must wait for 3 minutes before the
compressor can operate normally.
3. When the compressor starts, there is a little noise of
two-phase flow. After the compressor starts, the noise of
two-phase flow will disappear.
4. After the completion of drainage, screw off the inlet /
outlet pipe and take it off the machine. Otherwise,
siphonage will occur. Even if the drainage has stopped,
water will flow out of the machine.
5. Even if the drainage function of the machine is used to
drain the water in the tank, the water cannot be
completely drained. Therefore, when moving, carrying
and storing, the machine body should be upright and not
be dumped. In case of toppling, do not start the power
supply immediately, it should be placed for a period of
time, and start the power supply after the water is
completely evaporated.
6. Users should pay attention to the temperature of the
water in the water tank when draining water. Water in
tank should be drained at the temperature above 18℃. If
it is lower than 18℃, please use the heat storage function
to increase the water temperature before draining.
Otherwise, the ice in water tank may cause drainage
failure, or water cannot be emptied completely.
- 6 -
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
