Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Smart Features
EN
The RecoveryAir JetBoots also connect to the Therabody app via Bluetooth, giving
you control of your session from the convenience of your smartphone.
Not only can you easily access the Recover and Warm-up treatment options, but you
can also adjust the pressure and time.
Scan the QR code
to get started.
RecoveryAir JetBoots Programs
About negative gradient for all programs:
The RecoveryAir JetBoots' unique true negative gradient of pressure sequentially travels up the limb from the foot toward the heart in four internal overlapping chambers.
The spiraling overlap of chambers safely maximizes circulation.
• The pressure can be the same in two consecutive chambers, but the pump won't allow a back chamber to have a higher pressure than a front chamber.
• ● T he minimum pressure level of each chamber is 20 mmHg.
Recover and Warm-Up preset programs
• Access the Recover and Warm-Up preset programs via the Therabody app.
• The Recover program is the perfect go-to when experiencing fatigue, tension, or soreness brought on by your everyday activities or post workout.
• The Warm-Up program is recommended for use before workout.
• The only difference between the two programs is the default pressure level and treatment time.
Sequential inflation cycle
Both the Recovery and Warm-Up preset programs use the Sequential inflation cycle.
• ● A directional massage is applied, starting at the base of the treated area, and progresses upwards towards the torso and then releases.
• Starting with Chamber 1, once the inflating chamber has reached its preset pressure level, the pressure level for that chamber is held and the next chamber begins inflating.
Charging the RecoveryAir JetBoots
You can use your JetBoots while they are charging. Also, you can charge one of the boots at the time directly with the power adapter.
1. After turning off the integrated pump, locate the power charging port found at the front right side of the foot of the boot.
2. Connect one side of the splitter to the charging port.
3. Do the same for the second boot.
4. Connect the other end (female end) of the splitter to the power adapter and connect the other side to a wall power outlet.
5. Charging is complete when all 3 LED lights of the LED battery indicator are lit.
4
Werbung
Inhaltsverzeichnis
