Filling And Draining The Solution Tank; Draining The Recovery Tank - Comet Spa CPS 36 E Bedienungsanleitung

6.8. FILLING AND DRAINING THE SOLUTION
TANK
☞ The temperature of the water or the detergent
should never exceed 50°C.
☞ Always empty the recovery tank ( Photo 1 - B ) be-
fore filling the solution tank ( Photo 1 - D )
To fill the tank:
- Pour into the tank the required quantity of the
chemical product, considering the percentage indi-
cated by the supplier, with reference to the full tank
capacity listed on the product sheet.
• Use only those products suitable for the floor and
the dirt to be removed.
- Pour water in the filling opening placed in the front
of the machine ( Photo 28 - A ).
Leave 2 cm between the filling opening and the liquid
level. Do not fill beyond this point!
• The machine have been designed for the use
with non-foaming and biodegradable detergents
made specifically for scrubber-driers. The use
of other chemical products (such as sodium hy-
pochlorite, oxidizers, solvents or hydrocarbons)
may damage or destroy the machine.
- Follow the safety regulations specified in the relative
section and indicated on the detergent container.
- Contact the machine manufacturer to obtain a com-
plete list of available and suitable detergents.
☞ Always use non-foaming and biodegradable
detergents
- Do not leave the water hose unattended and insert
it completely into the tank: the hose might move and
get sensitive parts of the machine wet.
Close the tank with its foam plug.
A
Photo 28
A) Solution tank filling opening
6. OPERATING INFORMATIONS
To drain the tank:
- Unscrew the cap of the water filter placed in lower
part of the solution tank and wait untul the tank is
completely empty ( Photo 29 - A ).
- Screw the water filter cap firmly.
A) Water filter cap for the drainage of the
solution tank
6.9.
The dirty water must be drained in accordance with
national regulations.
The user is completely responsible for ensuring com-
pliance with such rules.
After the detergent solution is finished, always empty
the recovery tank ( Photo O - 3) before filling it again.
In general, the recovery tank can be emptied when-
ever required, and even during intermediate phases
of the work cycle.
The recovery tank and solution tank volume are the
same and to avoid situations of potential danger for
the suction motor it is necessary to
empty the recovery tank ( Photo 1 - B ) before filling
the solution tank ( Photo 1 - D ); in any case, a safety
float ( Photo 3 - B ) will stop the suction if the dirty
liquid level is too high
• If water or foam starts leaking from under the
tanks for any reason, immediately turn off the suction
motor and empty the recovery tank.
To drain the tank:
- Remove the recovery tank; to remove the recovery
tank, detatch the suction hose from its siege ( Photo
4 - B ) and lift the tank by pulling it up as shown in
Photo 13.
- Carry the recovery tank to a suitable location to drain
the dirty water and preferably near a toilet or a sewer
drain (comply with the national regulations for waste
water disposal).
43
Photo 29

DRAINING THE RECOVERY TANK

A