General Information; Manual Purpose; Terminology And Symbol Legend; Product Identification - Comet Spa CPS 36 E Bedienungsanleitung

1.

GENERAL INFORMATION

1.1.

MANUAL PURPOSE

To make it easier to read about and look up various
subjects, refer to the table of contents at the begin-
ning of the section in your language.
This manual has been prepared by the manufacturer
and is an integral part of the product. As such, it must
be kept in a safe place for the machine's entire service
life until demolition.
The customer must ensure that machine operators
have read or are familiar with the contents of this
manual so that they strictly follow the instructions
described herein.
Constant compliance with the instructions provided
in this manual is the only way to guarantee the best
results in terms of safety, performance, efficiency and
service life of the product you now own. Non-com-
pliance with these rules may cause injuries to people
and damage to the machine, the scrubbed surface
and the environment: in no case can such injuries or
damage be attributed to the manufacturer.
This manual refers in detail to the machine and pro-
vides instructions and descriptions only about the
battery and the battery charger provided.
1.2.

TERMINOLOGY AND SYMBOL LEGEND

For the sake of clarity and to efficiently highlight the
various aspects of the instructions provided, terms
and symbols were used that are defined and illus-
trated here below:
- Machine. This definition replaces the commercial
name to which this manual refers.
- Operator. 'operator' means the person or persons
given the task of installing, operating, adjusting,
maintaining, cleaning, repairing or transporting ma-
chinery.
- Technician. A technician is considered a person
who has the experience, technical education, legis-
lative and regulatory knowledge that allows him to
carry out any type of required work, and the ability to
recognise and to avoid possible risks during machine
installation, and maintenance.
☞ - INDICATION SYMBOL Particularly important in-
formation to avoid machine malfunctions.
• - ATTENTION SYMBOL Very important informa-
tion to avoid serious damage to the machine and to
the environment in which it operates.
• - DANGER SYMBOL Vital information to avoid se-
rious (or extreme) consequences affecting the health
of persons and causing damage to the product and
the environment in which it operates.
1. GENERAL INFORMATION
1.3.
The nameplate located under the dashboard,
above the battery connector, contains the infor-
mation.
1.4.
This appliance is suited for the commercial use,
e.g. in hotels, schools, hospitals, factories, shops,
offices, and rental companies.
This machine is a floor scrubber-drier: it must be used
to scrub and to vacuum liquids of flat, rigid, horizon-
tal, smooth or moderately rough and uniform floors
that are free from obstacles in both civic and indus-
trial environments. Any other use is prohibited.
Please refer very carefully to the safety information
reported in this manual.
The scrubber-drier distributes a quantity of a water
and detergent solution (adjustable) on the surface
to be cleaned, while the brushes remove any dirt on
the ground. The machine's suction system, using a
ground squeegee, perfectly dries the liquids and the
dirt just removed from the front brushes in a single
pass.
By efficiently combining a cleaning detergent with
various types of brushes (or abrasive disks), the ma-
chine can adapt to all the various combinations of
floors and dirt.
1.5.
The manufacturer reserves the right to make techni-
cal modifications to the product, without prior notice,
in order to make the necessary technical upgrades or
improvements. For this reason, some details of your
machine may be different from the information in the
sales catalogues or from the illustrations presented
in this booklet. However, this will not reduce safety
or invalidate the information supplied to this regard.
28
Total weight (ready to operate)
Max. working range incline 2%
(Max. transporting range incline 10%)
Rated power brush drive
Rated power suction turbine

PRODUCT IDENTIFICATION

SPECIFIC USE

TECHNICAL MODIFICATIONS