Herunterladen Inhalt Inhalt Diese Seite drucken

Machine Preparation; Battery Charging - Comet Spa CPS 36 E Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 76
6.
OPERATING INFORMATIONS
6.1.

MACHINE PREPARATION

• Before starting to work, wear non-slip shoes,
gloves and any other personal protection device indi-
cated by the supplier of the detergent used or consid-
ered necessary based on the operating environment.
☞ Do the following before starting to work. Refer
to the relative sections for a detailed description of
these steps:
Check the battery charge level and charge the battery
if necessary (see 7.2).
assemble the brush or pad driver (with the abrasive
pad) that are suitable for the surface and work in-
volved (see 7.3).
Assemble the squeegee, check that it is solidly at-
tached and connected to the suction hose and that
the drying blades are not too worn (see 7.5).
Fill the detergent solution tank with a mix of clean
water and non-foaming detergent in an adequate
concentration through the anterior hole. Leave 2 cm
between the mouth of the plug and the level of the
liquid (see 7.9).
☞ To avoid risks, become familiar with the machine
movements, carrying out test runs on a large surface
without obstacles.
To obtain the best results in terms of cleaning and
equipment service life, you should do the following
simple but important operations:
- Identify the work area, moving all possible obstacles
out of the way; if the surface is very extensive, work in
contiguous and parallel rectangular areas.
- Choose a straight work trajectory and begin working
from the farthest area to avoid passing over areas that
have already been cleaned.
6.2.

BATTERY CHARGING

Connect the patch cord to the power cable of the bat-
tery charger ( Photo 19 - A ) and to the mains power.
When switching on, the battery charger CBHD1 will
check the battery voltage and decide whether to start
the charging process. If the battery is not connected
A
Red LED
Photo 18
6. OPERATING INFORMATIONS
B
Yellow LED
Green LED
to the battery charger, the red LED will flash ( Photo
18 - A ). If the result of the test is positive after 1 sec-
ond the charging of the battery can start, with the red
LED on.
The progress of the charging process is shown by
three LED's: red, yellow and green, as in the whole
range of the battery chargers.
The green LED ( Photo 18 - C ) shows the end of the
charging. Disconnect the battery charger from the
mains power.
• For further information refer to the use and safety
manual of the battery charger provided by the man-
ufacturer.
If the machine is equipped with Pb-Acid batteries,
charge only in a well-ventilated area, remove the re-
covery tank and open the battery plugs.
• Follow the steps indicated in the battery manufac-
turer's operating and safety manual (see the battery
maintenance section).
Use an hydrometer to check the element liquid inten-
sity on a regular basis: if one or more elements are dis-
charged and the others fully charged, the battery has
been damaged and should be replaced or repaired
(refer to the battery service manual).
Close the element plugs and lower the superior cover.
☞ If the batteries are not used for an extended period
of time, read the "Batteries" paragraph (see 8.7)
C
A) Battery charger power supply cable
B) Battery charger
39
B
A
Photo 19

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Cps 36 bx

Inhaltsverzeichnis