Power Of The Heater - Saunum Primary Set Bedienungs- Und Installationsanleitung

POWER OF THE HEATER

If there is sufficient insulation behind the
wall and ceiling covering, the power of the
heater is determined by the volume of the
sauna room. Non-insulated walls (brick,
glass block, glass, concrete, floor tiles, etc.)
need a more powerful heater. Add 1.2 m³
to the volume of the sauna room for each
square metre of uninsulated wall.
For example, a 10 m³ sauna room with
a glass door corresponds to the capacity
requirement of a 12 m³ sauna room. If the
sauna room has log walls, multiply the
volume by 1.5. The optimal sauna room
sizes for the sauna climate device Saunum
Primary Set are given in Table 1 (see pages
10–11). The height of the sauna room is
usu ally 2,100 to 2,300 mm.
The minimum height when installing the
sauna climate device Saunum Primary
Set is 1,800 mm.
Safety distances of the primary sauna
unit and the recommended location in
the sauna room.
20
Non-combustible
material
• Saunum Primary Set B – A and B
50 mm – model with a closed stone
basket.
• Saunum Primary Set – A and B
150 mm – model with an open stone
basket.
The device can be placed with its back­
side against the sauna room cladding
or panels!
21