Electric Heater Insulation Resistance; Installing And Replacing The Heating Elements; Warranty - Saunum Primary Set Bedienungs- Und Installationsanleitung

ELECTRIC HEATER
INSULATION RESISTANCE
During the final inspection of the electri-
cal installation, a leakage may be detected
when measuring the insulation resistance
of the sauna climate device, and which has
occurred due to the insulation material of
the heating elements absorbing moisture
from the air (storage, transport). After a few
uses of the sauna climate device, this mois-
ture will disappear.
NB! Do not connect the heater to the
mains via a residual­current device!
34
INSTALLING AND
REPLACING THE
HEATING ELEMENTS
The heating elements are connected to the
device via screw terminals. It is necessary
to disconnect the screw terminals before
removing the heating elements.

WARRANTY

With the Saunum device warranty, Saunum
guarantees that the product will be free
from defects in the materials and the
assembly for a specified period after the
date of purchase. If, during the warranty
period, the device is found to be defective
due to the use of substandard materials
or the quality of the assembly, Saunum's
recommended repair partners will repair or
replace the device or its defective part with-
out charge for labour and parts under the
conditions set out below. Saunum reserves
the right to decide whether to replace the
defective product component or to replace
the device with a new one. The replaced
defective product components remain the
property of Saunum.
Warranty conditions:
1. The warranty is only valid if a com-
pleted installation report is submit-
ted with the claim.
2. The device has been connected to
the power network by a qualified
electrician in accordance with the
regulations in force.
3. The warranty period of the sauna
climate device when used in a pri-
vate sauna is two (2) years.
4. The warranty period of the sauna
climate device when used in a pub-
lic sauna is one (1) year.
Not covered by the warranty:
1. Routine maintenance and clean-
ing of the device and replacement
of the components due to normal
wear and tear.
2. Adaptation or modification of the
device for any purpose other than
that indicated in the instructions
for use.
3. Risks arising from transport.
4. Damage resulting from the misuse
of the device.
5. Damage resulting from the
improper installation of the device;
6. Repairs to the device not carried
out by Saunum's recommended
repair partner (maintenance part-
ner).
7. Accidents, lightning, water, fire,
improper ventilation, or any oth-
er factor beyond the control of
Saunum.
8. Breakages caused by the use of
stones and salt balls not recom-
mended by Saunum.
9. The heating elements and the salt
balls.
35