Saunum Primary Set Bedienungs- Und Installationsanleitung Seite 9

NB! Contact a qualified service specia­
list to perform maintenance. In the case
of any disturbances in the operation of
the sauna climate device, the use of the
device must be stopped immediately
and the device must be inspected by a
person authorised by Saunum.
THE SAUNA CLIMATE DEVICE DOES NOT
HEAT OR BLOW AIR.
• Make sure that the heater fuses are
in working order.
• Make sure the connection cable is
connected.
• Make sure that the sauna climate
device is switched on.
• Increase the maximum tempera-
ture in the sauna room.
THE SAUNA ROOM HEATS UP SLOWLY.
THE WATER THROWN ON THE STONES
COOLS THEM DOWN QUICKLY.
• Make sure that the air circulation
fan of the sauna climate device is
switched off during the heating.
• Make sure that the fuses of the sau-
na climate device are in working
order.
• Make sure that all heating ele-
ments are hot (smouldering) when
the sauna climate device is ope-
rating.
• Increase the selected temperature
on the control device.
16
• Make sure that the power of the
heater is sufficient.
• Check the stones. Stones that are
placed too tightly, falling down/
sinking closer over time, or the
wrong type of stone may inter-
fere with the air flow through the
heater and therefore reduce the
heating speed.
• Make sure that the ventilation of
the sauna room is correct.
THE SAUNA ROOM HEATS UP QUICKLY,
BUT THE TEMPERATURE OF THE STONES
IS INSUFFICIENT. THE WATER THROWN
ON THE STONES FLOWS DOWN.
• Make sure that the power of the
heater is not too high. If the power
of the heater is suitable for the
sauna room, it takes 45–90 minutes
to reach the desired temperature in
a properly insulated sauna room.
• Make sure that the ventilation of
the sauna room is correct.
• Reduce the speed of the sauna
climate device fan.
THE WALL COVERING OR OTHER
MATERIAL NEAR THE HEATER BECOMES
DIRTY QUICKLY.
• Observe the safety distance
requirements.
• Check the stones. Stones that are
placed too tightly, stones falling
down/sinking closer over time, or
the wrong type of stone may inter-
fere with the air flow through the
heater and cause the surrounding
materials to overheat.
• Make sure that no heating ele-
ments are visible between the
stones. If the heating elements
are visible, lift the cooled stones
so that the heating elements are
completely covered.
NB! Too sparsely placed stones allow the
heating elements to overheat and worsen
the indoor climate of the sauna room. It
may cause a fire hazard!
THE WOODEN SURFACES OF THE SAUNA
ROOM BECOME DIRTY OVER TIME.
This process may be accelerated by:
• sunlight;
• heat from the heater;
• wall protectors (protection equip-
ment has poor heat resistance);
• fine particles from the stones.
THE HEATER SMELLS.
• See section HEATING THE SAUNA
ROOM page 12.
• A hot heater may amplify odours
mixed with air, but this, however,
is not caused by the sauna nor the
heater. Causes include paint, glue,
oil, spices, etc.
THE SAUNA CLIMATE DEVICE IS MAKING
NOISE.
• There is always a certain noise
when the fan is running. If it is not
uniform and/or accompanied by a
metallic sound, the fan is likely to
need maintenance or repair. Check
that there are no foreign objects in
the fan air vents.
• Try switching the fan to a lower
speed.
• Loud sounds are likely to be caused
by stones cracking due to heat.
• Thermal expansion of the heater
parts may cause noise when the
heater warms up.
17