Saunum Primary Set Bedienungs- Und Installationsanleitung Seite 14

1. Install the flue cap (A) and centre the
heater housing in relation to the cap (B).
A
B
Place the flue cap at the connection point
between the wall and the ceiling and fas-
ten with a mounting suitable for the base
material. It can be attached to the wall and/
or the ceiling. Centre the heater under the
cap and adjust the feet so that the device
is level.
26
2. Place the parts of the telescopic flue in-
side each other. Next, place the lower part
of the flue at the end of the flue socket and
adjust the feet of the heater; check the flue
and the housing to make sure the device is
level. Adjust the heater housing as needed.
Carefully lower the flues inside each other
into the flue socket on the top of the heater.
3. Hang the telescopic flue on the cap (A).
Install the radiation plate (B). Install the
radiation plate guide (C).
C
A
B
4. When installing the heating elements,
first secure the wires with screw terminals,
and then press the heating element onto
the upturned edges of the bottom plates of
the heater.
27