Ferm CDM1093 Originalbetriebsanleitung Seite 8

GB
Only lay down the appliance when it has stopped
running completely. Do not place it on a dusty
surface as particles of dust could get into the
mechanism.
Charging the battery
• The included battery is delivered in partly
charged condition.
• Only use the battery charger in a temperature
range between + 5 °C to + 40 ºC.
• Only use the battery charger in dry, ventilated
rooms.
Charging
Fig. F
One advantage of using Lithium-Ion batteries is
that, until the battery is almost empty, hardly any
power fading is noticeable. The machine can be
used until you start noticing that the power of the
drill is elapsed. The battery is discharged now
and needs to be charged.
• Remove the battery from the tool.
• Put the adapter plug of the net adapter in the
connector on top of the battery.
• Put the net adapter in the socket.The red
charging LED on the net adapter will illuminate
indicating the battery is being charged.
• When the battery is charged the red LED will
change into green.
• The charging process of a fully discharged
battery will take approximately 5 hours the first
time and afterwards approximately 3-5 hours.
After the charging time the red light will
switch to green! Remove the battery
within 5 hours from the charger.
In comparison to NiCd and NiMH cells,
Lithium-Ion cells have no memory effect due
to intermedial charging. While NiCd and NiMH
batteries need to be discharged before charging,
a Lithium-Ion block does not need to completely
discharged. This battery block can be charged at
any time despite its current power level without
losing much of its original power and endurance.
The charger is equiped with a special plug. This
Lithium-Ion battery pack is only to be charged
with this dedicated charger. The integrated
electronics in this dedicated charger is custom
made for this Lithium-Ion battery pack. Using
other chargers/adapters will cause irreversible
damage to the battery.
8
Lithium-Ion cells can be stored for a
long period without losing much of their
charge. When the machine is not being
used over a longer period of time, it is
best to store the battery in charged
. SERVICE & NTNCE
condition.
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
These machines have been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Cleaning
Keep the ventilation slots of the machine clean
to prevent overheating of the engine. Regularly
clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation
slots free from dust and dirt. If the dirt does not
come off use a soft cloth moistened with soapy
water. Never use solvents such as petrol, alcohol,
ammonia water, etc. These solvents may damage
the plastic parts.
Lubrication
The machine requires no additional lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
Warranty
The warranty conditions can be found on the
separately enclosed warranty card.
Ferm