Start Up; Electrical Connection; Cleaning; Storage - Scheppach DC500 Original Bedienungsanleitung

• Now fit the intermediate part (13) using a total of four
fillister head screws (17) (fig. 5).
• Place the housing cpl. with engine (3) on the ma-
chine stand and fix it with a total of eight fillister head
screws (17) (fig. 6).
8.2 Fitting the dust bag (fig. 7)
• Attach the dust bag (10) to the lower air outlet using
the clamp fitting (11) (fig. 7).
8.3 Fitting the filter bag (fig. 8)
• Insert the retaining rod (1) into the housing cpl. with
engine (3) and hook in the filter bag (2) (fig. 7).
8.4 Fitting the suction hose (fig. 9 + 10)
• Attach the suction hose (6) to the nozzle on the
housing cpl. with engine (3) and fix it with a hose
clamp (14) (fig. 9).
• Attach the hose coupling (8) to the other end of the
hose (6) using a hose clamp (14) (fig. 10).
9.

Start up

m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
9.1 Switching on/off, fig. 1
• To switch on, set the ON/OFF switch (4) to position
"I".
• To switch the device off again, set the ON/OFF
switch (4) to position "0".

10. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The cus-
tomer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
22 | GB
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
The printing of the type designation on the connection
cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high start-
ing current (from 3000 watts)!

11. Cleaning

m Attention!
Disconnect the mains plug before carrying out any
cleaning work.
We recommend that you clean the device directly after
every use.
Wipe swarf and dust off the machine from time to time
with a cloth.
Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic parts
of the device.
Make sure that no water can penetrate the device in-
terior.

12. Storage

• Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
• The optimum storage temperature lies between 5
and 30 ˚C.
• Store the power tool in its original packaging.
• Cover the power tool to protect it from dust or mois-
ture.
www.scheppach.com