Operating The Compressor; Inflating Tyres - AEG JP 10 Originalbetriebsanleitung

32 www.aeg-automotive.com

Operating the compressor

Attention!
Always wear suitable ear protectors and
safety goggles during operation!
Check the unit and compressed air hose (22) for
damage before every use! Do not operate damaged
units! Review the manufacturer instructions for the
item to be inflated before every use.
1. Remove the air hose (22) from the storage
compartment (14).
2. Select the desired valve adapter. Open the valve
quick coupling (23) by pushing the lock-on lever
away from the air hose (22).
3. now attach the valve adapters and push the
lever toward the air hose to lock it in place.
23
22
Changing the pressure unit (PSI, kPA or bar)
Repeatedly press the „MENU" button (11) until the
display (4) shows the desired pressure unit. The
default value flashes.

Inflating tyres

•
The tyre pressure increases as the temperature
rises. The recommended tyre pressure is typically
specified for cold tyres (approx. 20 °C). Please
refer to the owner's manual for your vehicle.
•
Do not check the tyre pressure on warm tyres
(e.g. after long trips).
Attention!
Do not operate the compressor for more than 6
minutes. After this time allow the unit to cool down
for 10 minutes!
1. No valve adapter required to inflate car tyres.
First remove the cap from the tyre valve.
2. Release the lock-on lever and place the valve
quick coupling (23) as far on the tyre valve as
possible. Close the lock-on lever in the process.
3. Verify the automotive valve lever plug is firmly
attached to the tyre valve by carefully pulling
on it.
4. Press the „+" (10) or „-" button (9) until the set
value in the display (4) corresponds with the
desired pressure.
5. Set the On/Off switch (15) to „I" to switch on the
compressor.
note:
The compressor can be switched off at any time by
setting the On/Off switch (15) to the „O" position.
The compressor increases the tyre pressure accor-
ding to the set value and stops automatically.
6. Set the On/Off switch (15) to „0" to switch off the
compressor.
24
7. Release the lock-on lever and remove the valve
quick coupling (23) from the tyre valve.
8. Also check the air pressure with a second
25
pressure gauge to determine the accurate value.
Repeat the process if the desired air pressure
26
has not been reached.
9. Then replace the valve cap on the tyre valve.
Inflating sporting goods, toys and recreational
products
Attention!
Do not operate the compressor for more than 6
minutes. After this time allow the unit to cool down
for 10 minutes!
10. First read the product manufacturer's instruc-
tions for inflating and the approved maximum air
pressure before inflating the product.
11. Open the product's valve cover.
12. Attach the corresponding valve adapters to the
valve quick coupling (23) and push it into the
item's valve. If the valve adapters comes out of
the valve whilst inflating, you will need to push it
into the valve with your hand whilst inflating.
13. Verify the valve adapter is securely connected to
the valve by carefully pulling on it.