Using The Leds; Jumpstarting - AEG JP 10 Originalbetriebsanleitung

Using the LEDs

The LEDs have three light functions Repeatedly
press the button (6) to set the desired light
function.
Press button
1 x
2 x
3 x
4 x

Jumpstarting

Preparations
1. Ensure the battery pack of the device is charged.
Do not jump start a car if the battery level is
below 30 %.
2. Be sure to follow the indications on jumpstarting
inside the vehicles' operator's manuals.
3. Set the parking brake on both vehicles.
4. Set gearstick to neutral, for automatic transmis-
sions to P.
5. Switch off ignition on both vehicles and all
devices.
6. Do not disconnect the drained battery from the
vehicle's electrical system.
Connecting
1
12V 220V
- +
MENÜ
OFF
ON
Place the jumper leads so they will not be tangled in
moving parts inside the engine compartment.
Connect the terminal clamps of the leads in the
following order:
1. Positive lead (red) to positive terminal of drained
battery.
2. Negative lead (black) to the negative pole on the
drained battery, or to a suitable mass (e.g. engine
block) on the vehicle.
Light mode
Steady light
Flashing light
S.O.S. function
Off
2
Caution!
Connect this earthing point to the vehicle earth
as far away from the battery as possible to avoid
igniting explosive gas which may be present.
A signal will sound if the battery was connected
with reverse polarity. In this case, do not press the
„JUMP START" dial (13). Disconnect the clamps and
connect the clamps as described above.
Starting
1. Set the „JUMP START" dial (13) to „ON".
2. Start the engine of the vehicle with the dischar-
ged battery (start for max. 8 seconds - wait at
least 3 minutes between attempts).
3. After successfully starting the engine of the ve-
hicle with the discharged battery, set the „JUMP
START" dial (13) to „OFF".
Disconnecting
note:
Before disconnecting the jumper leads the rear
and front defrost should be switched on in the
vehicle with the drained battery (do not switch on
vehicle lights). This will reduce possible voltage
spikes whilst disconnecting and prevent damaging
electrical parts.
Disconnect the terminal clamps in the following
order:
Caution!
When disconnecting the jumper cables, be careful
they do not come into contact with the moving
parts of the engine.
1. Negative lead (black) from earth point of vehicle
with drained battery.
2. Positive (red) battery cable.
After jumpstarting drive the broken-down vehicle
for a longer distance to charge the battery. you may
also recharge the battery with a charger.
Fully recharge the device after using it for jump
starting (see „Charging the device battery back").
English 31