Before Starting The Equipment; Operation - EINHELL TC-WB 600 Originalbetriebsanleitung

All manuals and user guides at all-guides.com
L sound pressure level ..................... 82.1 dB(A)
pA
K uncertainty .......................................... 2.5 dB
pA
L sound power level .......................... 95 dB(A)
WA
K uncertainty .......................................... 2.5 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Vibration emission value a
K uncertainty = 1.5 m/s
2
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
Anl_TC_WB_600_SPK9.indb 15 Anl_TC_WB_600_SPK9.indb 15
GB
3. Health damage caused by hand-arm vib-

5. Before starting the equipment

Warning!
Always pull out the power plug before making ad-
justments to the equipment.
5.1 Using as an electric blower (Fig. 2)
= 2.994 m/s
2
Slot the blower tube (1) onto the outlet (a) and
h
turn it clockwise to fasten it (Fig. 2).
5.2 Using as an electric vacuum cleaner (Fig.
•
•
•

6. Operation

6.1 On/Off switch (Fig. 3/Item 2)
Switching on:
To switch on, press and hold the On/Off switch
(2).
Continuous operation:
Secure the ON/OFF switch (2) with the locking
button (6).
Switching off :
Press the On/Off switch (2) briefl y or let go.
6.2 Speed control (Fig. 4)
The speed of the fan is infi nitely adjustable bet-
ween 6000 and 16000 rpm using the speed cont-
roller (Fig. 4).
- 15 -
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5-7)
Slot the blower tube (1) onto the inlet (b) and
turn it clockwise to fasten it (Fig. 5).
Then slot the dust bag (5) onto the outlet (a)
and turn it clockwise to fasten it (Fig. 6).
Dust and dirt can now be suctioned up with
the blower tube (1) and land in the dust bag
(5).
15.07.2020 11:27:30 15.07.2020 11:27:30