Technical Data; Before Starting The Equipment - EINHELL GE-CF 18/2200 Li Originalbetriebsanleitung

case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Motor power supply: .............................. 18 V DC
Max. air speed: ........................................15 km/h
Blower size: ............................................ 180 mm
Weight: . ....................................................1.15 kg
The tool can only to be used with the unit provi-
ded, especially the charger and battery packs,
other units may cause great danger!

5. Before starting the equipment

5.1 Fitting the battery (Fig. 4)
Press the pushlock button (b) of the battery as
shown in Fig. 4 and push the battery (a) into the
mount provided (11). Make sure that the pushlock
button engages properly! To remove the battery,
proceed in reverse order!
5.2 Charging the lithium battery pack
(Fig. 4/5)
1. Remove the battery pack (a) from the battery
mount (11), pressing the push/lock button (b)
downward to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
into the mains socket outlet. The green LED
will then begin to fl ash.
3. Push the battery pack onto the battery char-
ger.
In section "Charger indicator" you will fi nd a table
with an explanation of the LED indicator on the
charger.
If the battery pack fails to become charged, ple-
ase check
•
whether there is voltage at the socket-outlet
•
whether there is proper contact at the char-
GB
ging contacts on the charger.
If the battery still fails to become charged, please
return
•
the charger
•
the battery pack
to our Customer Service Department.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.3 On/Off switch (Fig. 3/Item 3)
Switching on:
•
Press the On/Off switch (8).
•
The cordless blower will then come on at the
lowest level.
Switching off :
•
Press the On/Off switch (8) again.
5.4 Adjusting the blower level (Fig. 3/Item 4)
•
The blower has three setting levels for indivi-
dual adjustment to the particular situation.
•
The cordless blower always switches on at
the lowest level.
•
To raise the blower level, press on the blower
level selector (9).
•
The blower level will go up one level with
each press.
•
The current blower level is shown by the blo-
wer level indicator (10).
5.5 Adjusting the blower position
•
You can adjust the blower to any position by
turning the blower head.
•
To do so, undo the fastening screw (7) on the
right-hand side of the device.
•
Now adjust the blower to the position you
want and retighten the fastening screw (7).
- 14 -