Operating Mode - Steinberg Systems SBS-MD-12 Bedienungsanleitung

5. Electromagnetic and electrical disturbance around the target.
6. Metal digging tools located in the device operation area.
3.3.6. SBS-MD-17
ASSEMBLY
1. Loosen the clamping screw on the search coil and remove the connector. Place
washers on both sides of the low tube. Then attach the tube to the search coil, align
the mounting holes and tighten the connector.
2. Press the spring clip on the end of the low tube and slide it into the top tube. Adjust
the length to feel comfortable when using the device (measure the length standing
straight with the device in your hand and the search coil parallel to the ground). Turn
counterclockwise to tighten the locking nut.
3. Mount the control panel on the top tube and tighten with the mounting screw.
4. Wrap the search coil cable around the entire tube of the device and connect to the
control panel. Do not force the plug in.
5. Adjust the length of the device to your height so that you can hold it in your hand in
an upright position when you are standing. The search coil should be positioned
approximately 1-5 cm above the ground. Tighten the lock nut.
6. Adjust the search coil angle. Loosen the knobs on the end of the search coil and
adjust it to the desired angle. The search coil should be parallel to the ground. Tighten
the knobs so that the search coil does not rotate or wobble sideways.
INSTALLING BATTERIES
1. Make sure the power supply is turned off.
2. Remove the battery cover.
3. Insert two 9V batteries into the battery compartment according to the polarity
marked inside the compartment.
Note!
If the device will not be used for a long time, remove the batteries.
When low battery is indicated on the control panel display, the battery needs to be
replaced.
INTERNAL SPEAKER
The internal speaker can be turned off by connecting headphones to the device. The
3,5 mm headphone plug should be connected to the socket on the back of the control
panel. It is recommended to connect headphones with volume control.

OPERATING MODE

The device has 3 operating modes in the order of DISC - ALL METAL - NOTCH-DISC.