Steinberg Systems SBS-MD-12 Bedienungsanleitung Seite 51

3. Mount the control panel on the top tube and tighten with the mounting screw.
4. Wrap the search coil cable around the entire tube of the device and connect to the
control panel. Do not force the plug in.
5. Adjust the length of the device to your height so that you can hold it in your hand in
an upright position when you are standing. The search coil should be positioned
approximately 1-5 cm above the ground. Tighten the lock nut.
6. Adjust the search coil angle. Loosen the knobs on the end of the search coil and
adjust it to the desired angle. The search coil should be parallel to the ground. Tighten
the knobs so that the search coil does not rotate or wobble sideways.
INSTALLING BATTERIES
1. Make sure the power supply is turned off.
2. Remove the battery cover.
3. Insert two 9V batteries into the battery compartment according to the polarity
marked inside the compartment.
Note!
If the device will not be used for a long time, remove the batteries.
When low battery is indicated on the control panel display, the battery needs to be
replaced.