Steinberg Systems SBS-MD-12 Bedienungsanleitung Seite 56

INTERNAL SPEAKER
The internal speaker can be turned off by connecting headphones to the device. The
3.5 mm headphone plug should be connected to the socket on the back of the control
panel. It is recommended to connect headphones with volume control.
OPERATING MODES
DISC - Use to identify the type of target or to eliminate an unwanted metal object.
ALL METAL - The device will search for metal objects of all kinds.
USING THE DEVICE
1. Press the POWER button to turn the device on. All symbols will appear on the
display. After about two seconds, the display will show three blank frames with icons
for the detected object. At this point, you can start working with the device. In this
case, the device will detect all types of metal.
2. When the device finds a metal object, it will emit a sound signal and an icon with a
black base will appear on the display. The depth at which the target is located will also
be displayed. However, it should be remembered that this will be an approximate
depth. Actual depth may vary.
3. By using the DISC button you can eliminate the unwanted metal type. You can
eliminate the first and second metal category.
To eliminate the first category, press the DISC button once. To eliminate the second
category, press the DISC button again. The device will not respond to the eliminated
categories.
If the DISC button has not been pressed, the unit will operate in the ALL METAL mode.
All types of metal can be detected.
Categor 1.
y
Target Iron / metal bottle cap
4. To test the efficiency of the device, place it on a wooden or plastic table and
remove all metal jewelry (rings, watches, bracelets) from your hands. Position the
search coil so that it is facing the ceiling. If you want to test the device outdoors,
2.
Iron / metal bottle caps / screws,
small coins, gold rings, crown caps,
zinc items and certain copper
items.