Sound Signal - Steinberg Systems SBS-MD-12 Bedienungsanleitung

SOUND SIGNAL

Low tone
Medium
tone
High
tone
OVERLOAD WARNING
If the device detects a large metal object or the soil is highly magnetized and the
search coil is very close, the device will be overloaded. The display will go blank and an
overload message will appear. The device will also emit a special acoustic signal.
Overloading is not harmful to the device but will affect its operation in such
conditions. To prevent this, raise the search coil or change the place of search.
3.3.4. SBS-MD-15
ASSEMBLY
1. Loosen the clamping screw on the search coil and remove the connector. Place
washers on both sides of the low tube. Then attach the tube to the search coil, align
the mounting holes and tighten the connector.
2. Press the spring clip on the end of the low tube and slide it into the top tube. Adjust
the length to feel comfortable when using the device (measure the length standing
straight with the device in your hand and the search coil parallel to the ground). Turn
counterclockwise to tighten the locking nut.
Indicates that the target is probably a piece of iron or a
nail, screw, bottle cap. Slightly oxidized metal can be
detected, such as a 25 cents coin.
Indicates that the target is probably a 5 cents coin, an
aluminum can, a nickel item or a little gold ring. One cent,
a small zinc or copper coin would also fall into this
category.
Indicates that the target could be a silver 25 cents coin.
Some large aluminum and copper coins may also fall into
this category.